1. As the vibration cable is passively distributed, it is particularly suitable for use in special places where flammable and explosive sources are not suitable for power supply.
2. Built-in network module, which can be interconnected with other network equipment such as the alarm host and the computer in the control room through the network.
3. The alarm response speed is fast. When the fence is invaded or the vibration cable is damaged, the control panel alarm host immediately alarms.
4. Zone address setting, the detector can set the zone address quickly and arbitrarily.
5. Intelligent display, showing the detector's running status, pulse voltage value, working mode, alarm status, etc.
6. Compatible with all alarm hosts that accept switching signals to achieve multiple functions such as remote networking.
网络型) Vibration cable detector ( network type )
ZAZJ-W2-Z1 / Z2-TCP
摇晃/断线/断电/短路/防拆 Vibration / shake / disconnection / power failure / short circuit / anti-disassembly
档 64 stops
～ 4档 1 to 4 steps
米（电缆长度） ≤ 400 meters (cable length)
℃～ +70 ℃， 0 ～ 95%相对湿度、无冷凝 -40 ℃ to +70 ℃, 0 to 95% relative humidity, non-condensing
警号 Sound and Light / Sirens
防区报警独立输出DC12V Support , zone alarm independent output DC12V
～ 240V/DC12V/蓄电池12V7AH AC110 ～ 240V / DC12V / Battery 12V7AH
300 × 200 × 100mm / 2Kg
报警开关量独立输出(常开/常闭任选),联动控制LED探照灯/地址模块等其它报警设备 Support , alarm switch independent output ( normally open / normally closed optional ), linkage control LED searchlight / address module and other alarm equipment
φ 4mm外层抗紫外线 Outer diameter : φ 4mm
米约10KG 400 meters about 10KG
型/S型/C型/一字型 M / S / C / Slot
米，馈线与探测器BNC接口连接 Standard length of 3 meters, the feeder is connected to the BNC interface of the detector
All kinds of fences and fences built by iron mesh, iron art, plastic steel, brick wall, etc.
Previous Product : Z Series-Vibration Cable
Next product : None